Ridgid OL50135AL Air Compressor Manual

The Ridgid OL50135AL is a powerful air compressor designed for both professional and DIY use. It features a robust motor, large tank capacity, and multiple outlets for various pneumatic tools. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: High-efficiency motor, large capacity tank, multiple air outlets, pressure gauge, and safety valve.

Feature	Description
High-efficiency motor	Provides reliable power for various applications
Large capacity tank	Holds sufficient air for extended use
Multiple air outlets	Allows for simultaneous use of multiple tools
Pressure gauge	Displays current air pressure
Safety valve	Prevents over-pressurization

Installation

Unpack and inspect the compressor. Place it on a stable surface away from moisture.

Connect the air hose: Ensure the hose is securely attached to the compressor outlet.
Plug into a power source: Use a grounded outlet to prevent electrical hazards.
Check for leaks: Turn on the compressor and inspect for any air leaks.

WARNING! Ensure the compressor is on a flat surface to avoid tipping.

First-Time Setup

Power on the compressor; follow the setup instructions.

Set the desired pressure: Adjust the regulator to the required PSI.
Test the compressor: Run the compressor to ensure it builds pressure correctly.
Check all connections: Ensure there are no leaks before use.

CAUTION! Always wear safety goggles when operating the compressor.

Specifications

Model: Ridgid OL50135AL
Tank Capacity: 5 gallons
Max Pressure: 135 PSI
Motor Power: 1.5 HP
Weight: 60 lbs
Dimensions: 24 x 18 x 20 inches
Noise Level: 75 dB

Controls and Settings

Access the control panel to adjust pressure settings and monitor performance.

Controls: Power switch, pressure regulator, and safety valve.

Ensure all settings are adjusted according to the tool requirements before operation.

Connecting Devices

Connect pneumatic tools using the air hose.

Turn off the compressor before connecting tools.
Ensure the hose is securely attached to both the compressor and the tool.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check for leaks after connecting devices.

Operating the Compressor

Follow these steps to operate the compressor safely.

Power on the compressor and allow it to build pressure.
Use the regulator to set the desired pressure for your tool.
Monitor the pressure gauge during operation.

WARNING! Do not exceed the maximum pressure rating.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank regularly to prevent moisture buildup.
Check and replace the air filter as needed.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Read all safety instructions before operating the compressor.

Always wear protective gear.
Keep the compressor in a dry, well-ventilated area.
Do not operate in flammable environments.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power supply issue	Check power cord and outlet.
No pressure build-up	Leak in the system	Inspect for leaks and tighten connections.
Excessive noise	Loose parts	Tighten all screws and bolts.
Overheating	Blocked vents	Ensure vents are clear and clean.

Reset: Unplug and plug back in to reset the system.

Service: For support, contact Ridgid customer service.